RDT test: design and function
From MalariaETC
Navigation
Go back
Test formats vary, but share common principles - this is illustrated for a single parasite antigen below.
| PART 1: Blood lysis and binding to labelled antibody |
(1) In a typical test lysis buffer is loaded into one window (A), then the blood sample in a second window (B). Following this the lysed blood sample diffuses along the strip encontering lablelled antibody (Ab) then continues to diffuse into the window (pink arrow).
(2) The same process is shown below with buffer (A'), blood sample (B) encountering antibody (Ab') where any parasite antigen encounters antibody to form immune complexes (shown in the window)."
| PART 1: Blood lysis and binding to labelled antibody |
A positive test test result:
(2) Where the parasite-antigen is present, the dye-labelled antibody will bind to that antigen to form a complex (binding=B). This dye-labelled antigen/antibody complex then diffuses along the strip until it encounters a second parasite-specific antibody immobilised as a band on the strip. This immobilised antibody “captures” the labelled antibody/antigen complex to form a visible line (capture 1 = C).
(3) The remaining lysed sample (containing labelled antibody not bound to parasite antigen) continues to diffuse along the strip. And encounters a further immobilised antibody that captures it. This forms a control line which indicates that test has been successfully performed (capture 2 = D).